Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Ford >> 2004 >> Mustang Mach 1, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 234 (Anti-Lock Brake System) >> Removal And Installation >> Hydraulic Control Unit >> Installation

Hydraulic Control Unit: Installation

WARNING: This page is about a different car, the 2003 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: The brake system must be bled after the HCU is installed or replaced. refer to BRAKE SYSTEM-GENERAL INFORMATION .
    Fig 1: Installing HCU Bracket Nuts To HCU
    G01623165Courtesy of FORD MOTOR CO.
    Fig 2: Installing Brake Lines From Hydraulic Control Unit
    G01623166Courtesy of FORD MOTOR CO.
  1. To install, reverse the removal procedure.
scientia non olet · About Mike's Workshop Manuals