Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Ford >> 2004 >> Explorer 4.0 E, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 486 (Seat System) >> Removal And Installation >> Lumbar Control Switch >> Installation

Lumbar Control Switch: Installation

WARNING: This page is about a different car, the 2004 Mercury Marauder, 2004 Mercury Grand Marquis, and 2004 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.

    Marauder 

  1. Install the power lumbar switch until seated into bezel.
    Fig 1: Installing Power Lumbar Switch Until Seated Into Bezel
    G02756059Courtesy of FORD MOTOR CO.
  2. Connect the power lumbar switch electrical connector.
    Fig 2: Connecting Power Lumbar Switch Electrical Connector
    G02756060Courtesy of FORD MOTOR CO.
  3. Fasten the seat cushion cover J-clips.

    4. Crown Victoria / Grand Marquis 

  4. Connect the lumbar control switch electrical connector. Install the lumbar control switch.
    Fig 3: Connecting Lumbar Control Switch Electrical Connector
    G02756061Courtesy of FORD MOTOR CO.
  5. Install the cover.
    Fig 4: Installing Cover
    G02756062Courtesy of FORD MOTOR CO.

    6. Marauder 

  6. Install the affected seat. For additional information, refer to FRONT SEAT .

    7. All vehicles 

  7. Repower the SRS. For additional information, refer to AIR BAG RESTRAINT SYSTEMS .
scientia non olet · About Mike's Workshop Manuals