Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Ford >> 2004 >> Escape 2.0 B >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Automatic Transmission) >> Disassembly And Assembly Of Subassemblies >> Torque Converter Housing >> Assembly

Torque Converter Housing: Assembly

WARNING: This page is about a different variant/trim than selected.
  1. Position a new differential lube tube in the torque converter housing.
    Fig 1: Positioning Differential Lube Tube In Torque Converter Housing
    G02741225Courtesy of FORD MOTOR CO.
  2. Using the special tool, install the differential lube tube.
    Fig 2: Installing Differential Lube Tube
    G02741226Courtesy of FORD MOTOR CO.
  3. Install the differential lube tube bolt.
    Fig 3: Differential Lube Tube Bolt Torque Specification
    G02741227Courtesy of FORD MOTOR CO.
    4. NOTE: The final drive ring gear is installed with the lug end uppermost.
    Fig 4: Installing Final Drive Ring Gear
    G02741228Courtesy of FORD MOTOR CO.
  4. Install the final drive ring gear.
  5. Install the final drive ring gear retaining ring.
    Fig 5: Installing Final Drive Ring Gear Retaining Ring
    G02741229Courtesy of FORD MOTOR CO.
  6. Install the cooler tube fitting.
    Fig 6: Installing Cooler Tube Fitting
    G02741230Courtesy of FORD MOTOR CO.
scientia non olet · About Mike's Workshop Manuals