Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Ford >> 2003 >> ZX2 Standard >> Repair and Diagnosis >> Restraints >> Restraints Control Systems >> Safety Belt System >> General Procedures >> Safety Belt Without Anchor Plate Thread Damage >> Replacement Of The Weld Nut And/Or Reinforcement

Replacement Of The Weld Nut And/Or Reinforcement

    NOTE: If the B or C-pillar safety belt anchor nuts or reinforcements are stripped or missing, they should be replaced with a new nut/reinforcement plate.
  1. Expose the suspect anchor plate.
  2. Drill out two 8 mm (5/16 in) diameter access holes adjacent to the weld nut clearance hole.
  3. Thread a length of copper welding wire through the clearance hole and position to secure the weld nut and washer.
  4. Use MIG Wire Feed Welder to plug weld a 7/16 inch weld nut and standard washer in place at the two 8 mm (5/16 in) holes.
  5. Metal finish as required.
  6. Perform the Functional Test. For additional information, refer to COMPONENT TEST  .
scientia non olet · About Mike's Workshop Manuals