Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Ford >> 2003 >> ZX2 Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Transaxle/Transmission External Controls) >> Removal And Installation >> Brake Shift Interlock Actuator >> Removal

Brake Shift Interlock Actuator: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Remove the transmission control selector dial bezel; refer to BEZEL - TRANSMISSION CONTROL SELECTOR DIAL .
  2. Disconnect the brake shift interlock actuator electrical connector.
    Fig 1: Disconnecting Brake Shift Interlock Actuator Electrical Connector
    G01372223Courtesy of FORD MOTOR CO.
  3. Disconnect the park range switch electrical connector.
    Fig 2: Disconnecting Park Range Switch Electrical Connector
    G01372224Courtesy of FORD MOTOR CO.
  4. Remove the screws and the brake shift interlock actuator.
    Fig 3: Removing Brake Shift Interlock Actuator
    G01372225Courtesy of FORD MOTOR CO.
scientia non olet · About Mike's Workshop Manuals