Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Ford >> 2003 >> Excursion 7.3 F, 4WD >> Repair and Diagnosis >> Body & Frame >> Frames, Subframes & Crossmembers >> Body System - Full Frame And Body Mounting -- Excursion >> Removal And Installation >> Body Support-Rear, Crew Cab, Upper >> Removal

Body Support-Rear, Crew Cab, Upper: Removal

  1. NOTE: When removing upper body insulators, all other body mount support bolts have to be loose before raising the vehicle cab to prevent permanent structural damage from happening to the vehicle cab.

    Remove the rear lower body insulator; for additional information, refer to BODY SUPPORT-REAR, CREW CAB, LOWER  in this section.

  2. Remove the opposite side rear body insulator bolt; for additional information, refer to BODY SUPPORT-REAR, CREW CAB, LOWER  in this section.
  3. Remove and discard the left and right middle body insulator bolts; for additional information, refer to BODY SUPPORT-MIDDLE, CREW CAB, LOWER  in this section.
  4. Remove and discard the left and right front body insulator bolts; for additional information, refer to BODY SUPPORT-FRONT LOWER  in this section.
  5. Raise the vehicle cab enough to allow removal of the insulator.
  6. Remove the insulator.
    Fig 1: Locating Insulator
    G12743934Courtesy of FORD MOTOR CO.
scientia non olet · About Mike's Workshop Manuals