Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Ford >> 2003 >> Excursion 6.0 P, RWD >> Repair and Diagnosis (Single Page) >> Engine Performance >> Remove, Overhaul & Install >> Engine Controls - Removal & Installation - 6.0L (99P F450/550) Diesel >> Computerized Engine Controls >> Powertrain Control Module >> Removal & Installation

Removal & Installation

  1. Disconnect negative battery cable.
  2. On vehicles with dual batteries, see DUAL BATTERIES  under MISCELLANEOUS. Remove left battery.
  3. Disconnect Powertrain Control Module (PCM) connectors. Remove PCM mounting bolts and remove PCM. See Fig 1.
  4. To install, reverse removal procedure.
  5. Tighten PCM mounting bolts to specification. See TORQUE SPECIFICATIONS .
Fig 1: Removing & Installing PCM
G00250882Courtesy of FORD MOTOR CO.
scientia non olet · About Mike's Workshop Manuals