Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Ford >> 2002 >> Mustang Base, 2D Convertible, Standard >> Repair and Diagnosis >> Body & Frame >> Windows >> Power Window System >> Removal & Installation >> Window Regulator >> Removal & Installation (Front)

Removal & Installation (Front)

  1. Remove door trim panel. See DOOR TRIM PANEL . Remove door speaker. Remove interior weatherstrip from door frame. Remove 2 door window glass inner stabilizer bolts at top of door frame. Remove 2 door window glass inner stabilizers. Remove door window stop bracket screws, located near top of inside door frame. Remove door window stop brackets.
  2. Remove exterior weatherstrip rivet at top rear of door frame. Remove exterior weatherstrip. Remove 2 window regulator rivets. Tip front edge of window glass down to clear door filler. Remove door window glass. Disconnect window regulator motor harness connector. Remove 2 window regulator run channel screws located in middle of door frame. Remove window regulator run channel. Remove window regulator.
  3. To install, reverse removal procedure. Transfer parts to new window regulator as necessary. Tighten window regulator run channel bolts to specification. See TORQUE SPECIFICATIONS . Adjust door window glass. See DOOR WINDOW HEIGHT STOP  and STABILIZER  under ADJUSTMENTS.
scientia non olet · About Mike's Workshop Manuals