Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Ford >> 2002 >> Explorer 4.6 W, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Four-Wheel Drive Systems) >> Removal And Installation >> Four-Wheel Drive (4WD) Control Module >> Removal and Installation

Removal and Installation

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  2. Press in on the glove compartment at the points shown and lower the glove compartment.
    Fig 1: Pressing On Glove Compartment
    G02168702Courtesy of FORD MOTOR CO.
  3. Remove the 4WD control module.
    1. Disconnect the 4WD control module electrical connectors.
    2. Remove the two screws.
      Fig 2: Removing 4WD Control Module
      G02168703Courtesy of FORD MOTOR CO.
  4. To install, reverse the removal procedure.
scientia non olet · About Mike's Workshop Manuals