Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Ford >> 2001 >> Windstar Base >> Repair and Diagnosis >> Electrical >> Charging Systems >> Charging System - Generators & Regulators >> System Tests >> Test C: Battery Will Not Stay Charged

Test C: Battery Will Not Stay Charged

  1. Check for parasitic draw. Perform PARASITIC DRAW TEST  under ON-VEHICLE TESTING. If draw is greater than 50 milliamps, determine source of draw and repair as necessary. If draw is 50 milliamps or less, go to next step.
  2. Check generator output. Perform LOAD TEST  and NO-LOAD TEST  under ON-VEHICLE TESTING. If generator is okay, go to next step. If generator is not okay, continue diagnosis of PCM controlled charging system. See appropriate SELF-DIAGNOSTICS article in ENGINE PERFORMANCE.
    3. NOTE: Ensure battery is fully charged to perform this test.
  3. Verify condition of battery by using a battery analyzer. If battery is okay, go to next step. If battery is not okay, replace battery. Retest system operation.
  4. Check for parasitic draw from electronic modules. Perform ELECTRONIC MODULE PARASITIC DRAW TEST  under ON-VEHICLE TESTING. If electronic modules are okay, recharge battery and retest system operation. If electronic modules are not okay, replace appropriate module. Reconfigure as necessary. See MODULE CONFIGURATION under MODULE COMMUNICATIONS NETWORK - WINDSTAR article.
scientia non olet · About Mike's Workshop Manuals