Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Ford >> 2001 >> Windstar Base >> Repair and Diagnosis >> Body & Frame >> Power Seats System >> Removal & Installation >> Lumbar Seat Control Switch >> Removal & Installation

Removal & Installation

  1. Disconnect negative battery cable and wait one minute before proceeding. Remove seat. See SEAT ASSEMBLY  . Disconnect lumbar switch harness connector. Remove trim cover screw. Push side shield near seat belt buckle, lift up and release side shield retainer. Using appropriate tool, remove recliner handle cover. Lift and release side shield retainer. While holding side shield up, rotate side shield and disengage retainers.
  2. Using appropriate pin-type retainer removal tool, remove side shield front retainer and separate inboard side shield from seat. Disconnect hoses and remove trim cover. Remove lumbar seat control switch. To install, reverse removal procedure.
scientia non olet · About Mike's Workshop Manuals