Removal and Installation
WARNING: This page is about a different car, the 2005 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the driver air bag module. For additional information, refer to DRIVER AIR BAG MODULE .
- If equipped, remove the steering wheel spoke finish panels.
- Remove the speed control switches.
- Disconnect the electrical connectors.
- To install, reverse the removal procedure.
NOTE:
Carefully grasp and pull the edges to remove the steering wheel spoke finish panels.
NOTE:
Using a small, flat-bladed screwdriver, gently pry up the speed control switches from the steering wheel, beginning at the outer edge. Use care not to damage the steering wheel.