Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Ford >> 2000 >> ZX2 Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 185 (Engine Controls - Removal & Installation - Diesel) >> Computerized Engine Controls >> Powertrain Control Module >> Removal & Installation

Removal & Installation

WARNING: This page is about a different car, the 2003 Ford Econoline. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect negative battery cable. On vehicles with dual batteries, see DUAL BATTERIES  under MISCELLANEOUS. Remove air cleaner assembly. Loosen PCM harness connector retaining bolt and disconnect PCM electrical connector. Remove 2 PCM mounting nuts. Remove PCM cover and PCM. To install, reverse removal procedure. Tighten PCM mounting nuts and PCM harness connector bolt to specification. See TORQUE SPECIFICATIONS  .

scientia non olet · About Mike's Workshop Manuals