Removal and Installation

WARNING: This page is about a different car, the 2002 Lincoln LS. However, it is still accessible from the selected car via links, so may be relevant.

Remove the driver seat; see FRONT SEAT .
Release the driver seat module (DSM) bracket from the seat track.
1. Release the four retainers.
2. Release the module bracket.
Fig 1: Releasing DSM Bracket
Courtesy of FORD MOTOR CO.
Remove the DSM.
1. Disconnect the electrical connectors.
2. Remove the screws.
3. Remove the DSM.
Fig 2: Removing DSM
Courtesy of FORD MOTOR CO.

NOTE: Once the new module is installed, it is necessary to calibrate the seat. For additional information, see SEATING .

NOTE: It is important to make sure that the locking tabs are in the correct locations.

To install, reverse the removal procedure.