Driver-Side Air Bag Module: Installation
WARNING: This page is about a different car, the 2001 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
Remove air bag simulator from upper clockspring connector. Connect air bag module wiring connector to upper clockspring connector. Position air bag module on steering wheel. Install bolts and tighten to specification. See TORQUE SPECIFICATIONS . Install 2 cover plugs in back of steering wheel. With air bag simulators installed at remaining deployable SRS devices, prove out system. Activate air bag system. See ACTIVATING SYSTEM under DISABLING & ACTIVATING AIR BAG SYSTEM. Ensure system is functioning properly. See SYSTEM OPERATION CHECK .