Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Ford >> 2000 >> Mustang Base, 2D Convertible, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 235 (Supplemental Inflatable Restraint System) >> Disabling & Activating Air Bag System >> Disabling System >> Diagnostics Disabling Procedure

Diagnostics Disabling Procedure

WARNING: This page is about a different car, the 2004 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.

This procedure should only be used when performing air bag system diagnostics.

  1. Record pre-set radio frequencies for reprogramming. Disconnect negative battery cable. Wait at least one minute for back-up power supply to deplete stored energy.
  2. Remove driver-side air bag module. See DRIVER-SIDE AIR BAG MODULE  under REMOVAL & INSTALLATION. Connect Air Bag Simulator (418-F088/105-R0012) to clockspring connector at top of steering column (in place of air bag). See Figure .
  3. Open glove box door. Push in on tabs at sides of glove box door and open door to fullest extent. Remove right-side A/C register screws and register. Disconnect passenger-side air bag module electrical connector. Connect air bag simulator to vehicle harness side of passenger-side air bag connector (in place of air bag). Connect negative battery cable.
scientia non olet · About Mike's Workshop Manuals