Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Ford >> 2000 >> Explorer 4D Utility, 5.0 P, AWD >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission - Diagnosis - 4R70W >> Removal & Installation >> Powertrain Control Module >> Removal & Installation

Removal & Installation

Disconnect negative battery cable. Remove any component necessary to gain access to PCM. Loosen PCM connector retaining bolt, if equipped. Unplug harness connector from PCM. Remove 2 PCM mounting bolts/nuts. Remove PCM cover and PCM. To install, reverse removal procedure.

POWERTRAIN CONTROL MODULE LOCATIONS

Application Location
Crown Victoria, Econoline, Grand Marquis & Town Car Left Rear Of Engine Compartment, Near Brake Master Cylinder
Expedition, "F" Series Pickup & Navigator Right Rear Of Engine Compartment, Near Battery
Explorer & Mountaineer Right Rear Side Of Engine Compartment, Near Safety Wall
Mustang Behind Right Side Cowl Trim Panel
scientia non olet · About Mike's Workshop Manuals