Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Ford >> 2000 >> Contour SVT >> Repair and Diagnosis >> External Pages >> Different car >> Section 541 (Handles, Locks, Latches And Entry Systems) >> General Procedures >> Autolock and Horn Chirp Programming >> Using The Keyless Entry Keypad (If Equipped)

Using The Keyless Entry Keypad (If Equipped)

WARNING: This page is about a different car, the 2004 Mercury Monterey and 2004 Ford Freestar. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: A manual enable/disable mode allows the autolock feature to be turned off and on.
  1. Enter the 5-digit permanent entry code into the keyless entry keypad.
  2. Within 5 seconds of entering the code, press and hold the 7/8 button on the keypad.
  3. Within 5 seconds of step 2, and while holding the 7/8 button, press the 3/4 button on the keypad and release it.
    4. NOTE: If the autolock is disabled, the horn chirps once. If the autolock feature is enabled, the horn chirps once shortly and then sounds a second time for a longer sound of the horn once the above sequence is completed.
  4. Within 5 seconds of step 3, release the 7/8 button on the keypad.
scientia non olet · About Mike's Workshop Manuals