Speed Control Deactivator Switch: Installation

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: Do not allow brake fluid to contact the electrical connector.

Install the deactivator switch.
- Add a few drops of brake fluid to the fluid port on the threaded side of the switch before installing it.
- To install, tighten to 18 Nm (13 lb-ft).

Fig 1: Adding Drops Of Brake Fluid To Fluid Port On Threaded Side Of Switch

Courtesy of FORD MOTOR CO.

Check the master cylinder fluid level and adjust as necessary.

Fig 2: Checking Master Cylinder Fluid Level With Torque Specification

Courtesy of FORD MOTOR CO.

Connect the battery. For additional information, refer to BATTERY, MOUNTING AND CABLES article.