Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Ford >> 1999 >> Windstar Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 249 (Acceleration Control System) >> Removal And Installation >> Pedal >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2003 Ford Windstar. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the accelerator cable (9A758) from the accelerator pedal and shaft (9725).
    Fig 1: Removing Accelerator Cable From Accelerator Pedal And Shaft
    G01309301Courtesy of FORD MOTOR CO.
  2. Depress the tabs on the accelerator pedal retaining pin and remove the pin. Remove the accelerator pedal.
    Fig 2: Removing Accelerator Pedal
    G01309302Courtesy of FORD MOTOR CO.
  3. To install, reverse the removal procedure.
scientia non olet · About Mike's Workshop Manuals