Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Ford >> 1997 >> Contour SE, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 9 (Anti-Theft System) >> Removal & Installation >> Rap Module >> Removal & Installation

Removal & Installation

WARNING: This page is about a different car, the 1997 Mercury Mountaineer and 1997 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.

Module is located above and to rear of left rear wheelwell. Disconnect negative battery cable. Remove trim panel. Remove control module bracket screws. Unplug 22-pin connector, then 26-pin connector. Separate control module from retaining bracket. To install, reverse removal procedure.

scientia non olet · About Mike's Workshop Manuals