Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Ford >> 1997 >> Contour Base, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Controls - Tests W/Codes - 2.5L) >> Drive Cycles >> Fuel Monitor Or Ho2S Monitor Repair Verification Drive Cycle

Fuel Monitor Or Ho2S Monitor Repair Verification Drive Cycle

WARNING: This page is about a different variant/trim than selected.
  1. Refer to and complete the vehicle check and preparation before initiating the following repair verification steps. See VEHICLE CHECK/PREPARATION .
  2. Start the engine and drive the vehicle for 7 minutes:
    • Drive in stop-and-go traffic for 6 minutes, include one idle.
    • Accelerate to 45 MPH (72 km/h) at more than 1/2 throttle (Escort/Tracer 35 MPH [56 km/h]). Maintain speed for one minute.
  3. Rerun quick test. See QUICK TEST .
scientia non olet · About Mike's Workshop Manuals