Non-Generic OBD-II Parameter Identification (PID)

WARNING: This page is about a different variant/trim than selected.

Turn ignition switch to OFF position. Ensure test equipment is properly attached. Program scan tester using the following steps:

Select vehicle and engine selection menu. See Figure.
Select year, engine, model and any additional information requested by scan tester.
Select GENERIC OBD-II OPTIONS. Press CONT button if monitors are not complete.
Select DIAGNOSTIC DATA LINK.
Select PCM - POWERTRAIN CTRL MODULE.
Select DIAGNOSTIC TEST MODES.
Select PID DATA MONITOR AND RECORD.
Turn ignition on or start engine and allow to idle.
Follow operating instructions from scan tester menu.
Select PIDs and press START.