Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Ford >> 1996 >> Explorer 2D Utility, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 91 (Engine Controls - System/Component Tests) >> Emission Systems & Sub-Systems >> Air Injection >> Air Control Valve Operation

Air Control Valve Operation

WARNING: This page is about a different car, the 1995 Mazda RX-7. However, it is still accessible from the selected car via links, so may be relevant.
  1. Warm engine to normal operating temperature. Start engine and run at idle. Using jumper wire, ground terminal 4N at ECM connector. See PIN VOLTAGE CHARTS article for terminal identification.
  2. If engine idles rough, air control valve and switching valve solenoid are okay. See Figure . If engine does not idle rough, check vacuum routing, switching valve solenoid, air pump and air control valve.
scientia non olet · About Mike's Workshop Manuals