Continuous Memory Self-Test (Enhanced Mode)

Turn ignition switch to OFF position. Ensure test equipment is properly attached. Program scan tester using the following steps:

• Select vehicle and engine selection menu. See Fig 1 .
• Select year, engine, model and any additional information requested by scan tester.
• Select DIAGNOSTIC DATA LINK.
• Select PCM - POWERTRAIN CTRL MODULE.
• Select DIAGNOSTIC TEST MODES.
• Select RETRIEVE/CLEAR CONTINUOUS DTCs.
• Turn ignition on.
• Follow operating instructions from scan tester menu.

Fig 1: New Generation Star (NGS) Main Menu & Mode Path ID (Ranger & Windstar)

Courtesy of FORD MOTOR CO.