Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Ford >> 1994 >> Probe Base, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Cruise Control System - 2.0L A/T) >> Testing & Diagnosis >> Pinpoint Test A - System Or Function Inoperative >> Check Power To Servo

Check Power To Servo

WARNING: This page is about a different variant/trim than selected.

Unplug harness connector from servo. Turn ignition on. Using DVOM, measure voltage between pin No. 7 and chassis ground. See Figure. If battery voltage exists, go to CHECK POWER TO DEACTIVATOR SWITCH step. If battery voltage does not exist, check for battery voltage between pin No. 7 and chassis ground. If battery voltage exists, go to next step. If battery voltage does not exist, check or circuit for open. Repair or replace as necessary.

scientia non olet · About Mike's Workshop Manuals