Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Ford >> 1994 >> Probe Base, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Controls - Tests W/Codes - EEC 2.5L) >> Self-Diagnostic System >> Clearing Codes

Clearing Codes

WARNING: This page is about a different variant/trim than selected.
CAUTION: When battery is disconnected, vehicle computer and memory systems may lose memory data. Driveability problems may exist until computer systems have completed a relearn cycle. See COMPUTER RELEARN PROCEDURES article in GENERAL INFORMATION section.

To clear trouble codes, deactivate self-test by disconnecting jumper wire from PCM STI terminal at Data Link Connector (DLC). Disconnect negative (-) battery cable. Depress brake pedal for 5-10 seconds. All hard codes and intermittent codes will be erased from PCM memory.

scientia non olet · About Mike's Workshop Manuals