Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Ford >> 1994 >> Probe Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 31 (Engine Controls - Tests W/Codes - EEC-IV (4.6L)) >> Quick Test >> Continuous Monitor Mode (Wiggle Test) >> KOEO Wiggle Test Procedure

KOEO Wiggle Test Procedure

WARNING: This page is about a different car, the 1994 Mercury Grand Marquis, 1994 Lincoln Town Car, 1994 Lincoln Mark VIII, and 1994 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.

Connect test equipment. See Figure . Turn ignition on. Activate self-test using jumper lead or diagnostic tester. Wait 10 seconds, and then deactivate and reactivate self-test. Wiggle test mode is now activated. Tap, move and wiggle suspect sensor and/or harness area. If a fault is detected, a diagnostic trouble code may be stored in memory and indicated by the diagnostic tester or scan tester. Retrieve code, and perform the appropriate test. Refer to the DIAGNOSTIC CODE-TO-TEST REFERENCE MENUS  .

scientia non olet · About Mike's Workshop Manuals