Continuous Memory Self-Test (Enhanced Mode)
WARNING: This page is about a different car, the 1994 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
Turn ignition switch to OFF position. Ensure test equipment is properly attached. Program scan tester using the following steps:
- Select vehicle and engine selection menu. See Fig 1 .
- Select year, engine, model and any additional information requested by scan tester.
- Select DIAGNOSTIC DATA LINK.
- Select PCM - POWERTRAIN CTRL MODULE.
- Select DIAGNOSTIC TEST MODES.
- Select RETRIEVE/CLEAR CONTINUOUS DTC's.
- Turn ignition on.
- Follow operating instructions from scan tester menu.