Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Ford >> 1994 >> Probe Base, Standard >> Repair and Diagnosis >> Electrical >> Charging Systems >> Alternator - W/Internal Regulator - MITSUBISHI >> On-Vehicle Testing >> Amperage Output Test

Amperage Output Test

  1. Ensure drive belt is in good condition and properly tightened. Connect charging system load tester in accordance with manufacturer's instructions. Start and run engine at 2500-3000 RPM and apply load until alternator output levels off.
  2. Record maximum alternator output current. See ALTERNATOR OUTPUT SPECIFICATIONS table for output values. If alternator output is within 20% of rated output amperage, alternator output is okay. If alternator does not produce rated output, go to VOLTAGE OUTPUT TEST.
ALTERNATOR OUTPUT SPECIFICATIONS

Application Amps Rating
2.0L 80
2.5L 90
scientia non olet · About Mike's Workshop Manuals