Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Ford >> 1991 >> Probe GL, Automatic >> Repair and Diagnosis >> Accessories & Equipment >> Wiper/Washer Systems >> Testing >> Front Wiper Test >> INT Signal Test, Low Inoperative

INT Signal Test, Low Inoperative

  1. Ensure ignition is off. Set W/W switch to LOW position. Connect ohmmeter between ground and Red/Yellow wire at wiper/washer switch connector. If continuity does not exist, replace wiper/washer switch. If continuity exists, go to step 2).
  2. Connect ohmmeter between ground and Red/Yellow wire at interval governor connector. If continuity does not exist, repair open condition in Red/Yellow wire between interval governor and wiper/washer switch. If continuity exists, replace interval governor.
scientia non olet · About Mike's Workshop Manuals