Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Ford >> 1991 >> Bronco 4.9 Y, Standard, M5OD-R2 >> Repair and Diagnosis >> Steering >> Power Steering >> Steering System - Integral Power >> Overhaul >> Control Valve Housing >> Disassembly

Control Valve Housing: Disassembly

  1. Using Puller Attachment (T58L-101-B) and Slide Hammer (T59L-100-B), remove dust seal from rear of valve housing. Discard seal. Remove snap ring from valve housing. See Fig 1 .
    Fig 1: Exploded View of Control Valve Housing
    G71425Courtesy of FORD MOTOR CO.
  2. Turn valve housing over. Insert Driver Handle (T65P-3524-A2) and Bearing/Seal Remover (T65-3524-A3). Tap bearing and seal out of housing. Discard seal. If damaged, remove inlet tube seats using Tube Seat Remover (T74P-3504-L).
scientia non olet · About Mike's Workshop Manuals