Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Ford >> 1990 >> Bronco II RWD, Standard, M5OD-R1 >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Basic Diagnostic Procedures >> DISTRIBUTORLESS Ignition System (Dis) - No Start (4.0L) >> Test 5, Check IGND At EDIS

Test 5, Check IGND At EDIS

With key off, check resistance between J47 (IGND E) and J7 (BAT-). If resistance is less than 5 ohms go to TEST 6. If resistance exceeds 5 ohms, replace EDIS module and check for fault codes. See the appropriate TESTS W/CODES article.

scientia non olet · About Mike's Workshop Manuals