Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Ford >> 1984 >> Bronco II Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 19 (EEC-IV CEC System) >> Quick Test >> Quick Test Diagnostic Aids >> Output State Check

Output State Check

WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 1988 Ford Ranger, 1988 Ford RV Cutaway, 1988 Ford Pickup, 1988 Ford F-Super Duty, and 1988 Ford Econoline. However, it is still accessible from the selected car via links, so may be relevant.

The Output State Check is used as an aid in servicing output actuators associated with the EEC-IV system. It allows you to energize and de-energize most of the system output actuators on and off on command.

This mode is entered after all codes have been received from KOEO and CONTINUOUS SELF-TEST. At this time, leave SELF-TEST activated and depress throttle. Each time throttle is depressed and released, the output actuators will change state (go from on to off, or off to on).

scientia non olet · About Mike's Workshop Manuals