Sending Unit And Sensor, Fuel Level: Installation
WARNING: This page is about a different car, the 2020 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Do not touch the terminals or the resistor card.
CAUTION:
Do not handle the new fuel level sending unit by the float arm.
- Position the new fuel level sending unit to the fuel pump module reservoir.
- Gently push the fuel level sending unit down until the snap tab engages.CAUTION:
Ensure the fuel level sending unit wires are routed so they do not get pinched between the coils of the spring when the module is completely compressed.
- Connect the fuel level sending unit electrical connector (1).
- Install the fuel pump module. Refer to MODULE, FUEL PUMP, INSTALLATION .