Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Fiat >> 2018 >> 124 Spider Classica, Automatic Trans >> Repair and Diagnosis >> Engine Mechanical >> Fuel System >> Fuel Delivery >> Module, Fuel Pump >> Removal And Installation >> Submerged Pump Assembly Equipped With Level Gauge >> Installation

Submerged Pump Assembly Equipped With Level Gauge: Installation

  1. Put the fuel pump module in the tank and insert the gasket.
  2. Place the ring nut in position and secure it using the screws.
  3. Connect the electrical connection for the fuel pump and level gauge.
  4. Install the quick coupling and connect the fuel pipe.
  5. Position the fuel pump module cover in its housing and tighten the screws.
  6. Engage the wiring retainer.
  7. Fit in place the soft top housing compartment lining and secure the fasteners.
  8. Fit the soft top housing compartment side lining and secure the fasteners.
  9. Secure the rear window heater wiring.
  10. Place the seat belt and tighten the bolts to the proper specification. Refer to TECHNICAL SPECIFICATIONS .
  11. Connect the electrical connection of the seat belt.
  12. Position the rear lining and secure with fasteners.
  13. Position the hood release lever.
  14. Position the lining and secure using the fasteners.
  15. Fit the seat belt and put in place the front seat belt lining.
  16. Secure the front seat belt lining with fasteners.
  17. Take the roll bar lining and fit it in housing engaging the retainers.
  18. Connect the negative battery cable.
scientia non olet · About Mike's Workshop Manuals