Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Fiat >> 2012 >> 500 Pop, Automatic Trans >> Repair and Diagnosis >> Accessories & Equipment >> Communication Devices >> Electronic Control Modules (Service Information) >> Module, A/C And Heater >> Removal >> Removal

Module, A/C And Heater: Removal: Removal

NOTE:

Air inlet housing removed from view for clarity.

Fig 1: Wire Harness Connector, A/C Heater Module, HVAC Housing, Lower Module Retaining Screw
GC0152611Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect and isolate the negative battery cable.
  2. Remove the glove box. Refer to GLOVE BOX, INSTRUMENT PANEL, REMOVAL .
  3. Disconnect the wire harness connector (4) from the A/C heater module (2), located on the right side of the HVAC housing (5).
    NOTE:

    Use a flexible drive socket to remove the lower module retaining screw (3).

  4. Remove the three screws (upper 1 and lower 3) that secure the A/C heater module to the housing and remove the module.
scientia non olet · About Mike's Workshop Manuals