Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Fiat >> 2012 >> 500 Lounge, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 20 (Electronic Control Modules (Service Information) Except 500E) >> Module, Transmission Control [EAJ] >> Installation >> Installation

Module, Transmission Control [EAJ]: Installation: Installation

WARNING: This page is about a different car, the 2013 Fiat 500c and 2013 Fiat 500. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Electrical Connection, Nuts, Mounting Bracket & Electrohydraulic Selection Gearbox Electronic Control Unit
GC0153554Courtesy of CHRYSLER GROUP, LLC
  1. Install the electrohydraulic selection gearbox electronic control unit (1).
  2. Install the mounting bracket (3) and install the nuts (4) then tighten.
  3. Connect the electrical connection (2) for the electrohydraulic selection gearbox electronic control unit.
    Fig 2: Bolts & Electronic Control Unit Protection Cover
    GC0153553Courtesy of CHRYSLER GROUP, LLC
  4. Reposition the electronic control unit protection cover (2) install the bolts (1) and tighten.
  5. Only in the case of replacement, connect the Examiner and run the initialization procedure for the gear engagement/selection positions and check that the engagement position travel is correct.
scientia non olet · About Mike's Workshop Manuals