Test 7J - Bus Short To Battery
WARNING: This page is about a different car, the 1995 Dodge Stratus and 1995 Chrysler Cirrus. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
For connector terminal identification, see CONNECTOR IDENTIFICATION
. For wiring diagrams, see article in ENGINE PERFORMANCE:
After each repair, perform TEST VER-1.
Using scan tool in ohmmeter mode, check resistance of junction block internal 12-pin connector terminal No. 10. See Fig 1 . If resistance is more than 5 ohms, repair open ground circuit as necessary. If resistance is less than 5 ohms, replace BCM.