Test 7D - Bus Short To Battery
WARNING: This page is about a different car, the 1995 Plymouth Acclaim and 1995 Dodge Spirit. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
For connector terminal identification, see CONNECTOR IDENTIFICATION. For wiring diagrams, see article in ENGINE PERFORMANCE:
- WIRING DIAGRAMS - 2.5L TBI
- WIRING DIAGRAMS - 2.5L FLEXIBLE FUEL
- WIRING DIAGRAMS - 3.0L
After each repair, perform TEST VER-1 .
CAUTION:
Always turn ignition switch to OFF position prior to disconnecting or connecting any module connector.
Using scan tool in ohmmeter mode, check traveler module connector ground circuit. On AA body, check resistance at visual message center connector ground terminal (Black wire). See Fig 1 . If resistance is more than 5 ohms, repair open in Black wire or Black/Dark Green wire. If resistance is less than 5 ohms, replace traveler module.