Test 7D - Short To Battery
WARNING: This page is about a different car, the 1993 Dodge Dynasty, 1993 Chrysler New Yorker Fifth Avenue, 1993 Chrysler New Yorker, and 1993 Chrysler Imperial. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
For connector terminal identification, see CONNECTOR IDENTIFICATION
. For appropriate wiring diagram, see WIRING DIAGRAMS
at end of article.
CAUTION:
Always turn ignition switch to OFF position prior to disconnecting or connecting any module connector.
- Using DRB-II in ohmmeter mode, check traveler ground wire. On AG and AJ bodies, check resistance at traveler connector system ground circuit (Dark Green wire).
- If resistance is more than 5 ohms, repair open circuit in Dark Green wire. Perform VERIFICATION PROCEDURE VER-1. On AA body, check resistance at visual message center connector traveler ground terminal (Black wire).
- If resistance is more than 5 ohms, repair open circuit in Black wire. Perform VERIFICATION PROCEDURE VER-1. If resistance is less than 5 ohms, replace traveler module. Perform VERIFICATION PROCEDURE VER-1.