Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Eagle >> 1993 >> Vision ESi >> Repair and Diagnosis >> External Pages >> Different car >> Section 2 (Engine Controls - Tests W/Codes - Body Control Computer) >> Self-Diagnostic Tests >> Test 6B - Courtesy Light System

Test 6B - Courtesy Light System

WARNING: This page is about a different car, the 1993 Dodge Dynasty, 1993 Chrysler New Yorker Fifth Avenue, 1993 Chrysler New Yorker, and 1993 Chrysler Imperial. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: For connector terminal identification, see CONNECTOR IDENTIFICATION  . For appropriate wiring diagram, see WIRING DIAGRAMS  at end of article.
  1. Remove and inspect inoperative courtesy light bulb. If bulb filament is open, replace bulb. Perform VERIFICATION PROCEDURE VER-1. If bulb filament is okay, put DRB-II in voltmeter mode.
    CAUTION: DO NOT  allow DRB-II to touch any metal ground in following step.
  2. Check voltage of both bulb contacts of inoperative bulb socket. If voltage at one contact in bulb socket is more than 10 volts, repair open Yellow wire (ground circuit) to bulb socket. Perform VERIFICATION PROCEDURE VER-1. If voltage is less than 10 volts at one contact in bulb socket, repair open Pink wire (fused battery feed) to bulb socket. Perform VERIFICATION PROCEDURE VER-1.
scientia non olet · About Mike's Workshop Manuals