Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Eagle >> 1993 >> Vision ESi >> Repair and Diagnosis >> External Pages >> Different car >> Section 2 (Engine Controls - Tests W/Codes - Body Control Computer) >> Self-Diagnostic Tests >> Test 12D - Left Door Handle Switch Circuit

Test 12D - Left Door Handle Switch Circuit

WARNING: This page is about a different car, the 1993 Dodge Dynasty, 1993 Chrysler New Yorker Fifth Avenue, 1993 Chrysler New Yorker, and 1993 Chrysler Imperial. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: For connector terminal identification, see CONNECTOR IDENTIFICATION  . For appropriate wiring diagram, see WIRING DIAGRAMS  at end of article.
  1. Remove left front door trim panel. Turn ignition off. Disconnect illuminated entry switch connector. See Figure . Connect jumper wire between terminal No. 1 (White wire) and ground.
  2. Using DRB-II in ohmmeter mode, check resistance on terminal No. 16 (White wire) of Body Control Module (BCM) Black connector. If resistance is more than 5 ohms, repair open White wire between BCM and left front door illuminated entry switch.
  3. If resistance is less than 5 ohms, connect jumper wire between terminal No. 1 (White wire) and terminal No. 2 (Black wire) of illuminated entry switch connector. If resistance is less than 5 ohms, replace left front door illuminated entry switch. Perform VERIFICATION PROCEDURE VER-1. If resistance is more than 5 ohms, repair open Black wire. Perform VERIFICATION PROCEDURE VER-1.
scientia non olet · About Mike's Workshop Manuals