Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Eagle >> 1993 >> Vision ESi >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Tests W/Codes - 3.3L/3.5L >> Self-Diagnostic System >> Entering On-Board Diagnostics >> DRB-II Diagnostic Mode

DRB-II Diagnostic Mode

  1. Turn ignition off. Connect DRB-II to engine diagnostic connector. Engine diagnostic connector is located in engine compartment, near PCM.
  2. Start engine (if possible). With foot on brake, move transmission shift lever through all positions, ending in PARK. Turn A/C switch on and then off (if equipped).
  3. Turn engine off. Without starting engine again, turn ignition on. Enter FUEL/IGN FAULTS menu. Press "2" key selecting READ FAULTS. DRB-II will display fault messages.
  4. When DRB-II fault message is obtained, refer to appropriate test number. To clear fault codes, see CLEARING FAULTS .
scientia non olet · About Mike's Workshop Manuals