Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Eagle >> 1993 >> Vision ESi >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Tests W/Codes - 3.3L/3.5L >> Fault Code Tests >> Test FC-29B - EVAP Purge Solenoid Circuit

Test FC-29B - EVAP Purge Solenoid Circuit

NOTE: For connector terminal identification, see CONNECTOR IDENTIFICATION . For appropriate wiring diagram, see WIRING DIAGRAMS  at end of article.

Using an external ohmmeter, check resistance between EVAP purge solenoid terminals. If resistance is more than 5 ohms, repair ignition 12-volt feed wire for an open. Perform TEST VER-2. If resistance is less than 5 ohms, replace EVAP purge solenoid. Perform TEST VER-2.

scientia non olet · About Mike's Workshop Manuals