Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Eagle >> 1992 >> Talon Base, Standard >> Repair and Diagnosis (Single Page) >> Engine Performance >> Engine Controls - Adjustments >> Throttle Position Sensor (TPS) >> Engine Controls - Adjustments >> 1993

Engine Controls - Adjustments: 1993

  1. Ensure basic idle speed is set to specification. See IDLE SPEED SPECIFICATIONS table under IDLE SPEED. Install Test Harness Set (MB99138) between TPS and TPS connector. See Fig 1 . ConnectDigital Volt-Ohmmeter (DVOM) between TPS output terminals No. 2 and 4. Turn ignition on. DO NOT start engine.
  2. Check TPS voltage. Reading should be .48-.52 volt. Adjust TPS until correct voltage is obtained. Clockwise rotation of TPS increases output voltage. Turn ignition off, and disconnect DVOM. Disconnect negative battery cable for 10 seconds or more to clear any trouble codes.
Fig 1: Measuring Throttle Position Sensor Voltage (1993)
G93G39517Courtesy of CHRYSLER CORP.
scientia non olet · About Mike's Workshop Manuals