Enabling Conditions And Possible Causes
WARNING: This page is about a different car, the 2024 RAM ProMaster EV. However, it is still accessible from the selected car via links, so may be relevant.
| Faults | Monitoring Conditions | Set Conditions | Possible Causes |
|---|---|---|---|
| P0A1F-00 - Battery Energy Control Module A Internal Performance |
|
This DTC will set if the Battery Pack Control Module (BPCM) detects an internal fault |
|
| P1614-00 - ECU Reset/Recovery Occurred |
|
This DTC will set if the Battery Pack Control Module (BPCM) detects an internal fault |
|
| P1A01-00 - Battery Energy Control Module EEPROM Failure |
|
This DTC will set if the Battery Pack Control Module (BPCM) detects an internal fault |
|
| P1A06-00 - Battery Energy Control Module Read Only Memory (ROM) |
|
This DTC will set if the Battery Pack Control Module (BPCM) detects an internal fault |
|
| P1E1A-00 - Hybrid/EV Battery Control Board Hardware Performance |
|
This DTC will set if the Battery Pack Control Module (BPCM) detects an internal fault |
|
Default Actions:
- The BEV Service Lamp will illuminate.
WARNING:
On vehicles equipped with the high voltage system, you must thoroughly read and follow all High Voltage Safety procedures. In addition, before performing any diagnostic or service procedure near a high voltage component, you must perform the High Voltage Power Down. Failure to follow these instructions may result in possible serious or fatal injury.
Always power down the High Voltage System before performing diagnostic tests or repairs to the High Voltage system. Refer to VEHICLE HIGH VOLTAGE POWER DOWN .
Always perform the Pre-Diagnostic Troubleshooting procedure before proceeding. Refer to PRE-DIAGNOSTIC TROUBLESHOOTING PROCEDURE .