Diagnostic Test

READ AND RECORD DTCS AND ENVIRONMENTAL DATA - ERASE DTCS AND CHECK FOR DTC TO RETURN

NOTE:

Before proceeding with the diagnostic procedure, verify that the connections are properly made, seated and verify proper pin terminal tension. A loose connection at any of the SCCM connectors may cause the DTC to set.

With the scan tool, read DTCs in all Electronic Control Units (ECUs) and record on the repair order.
For future reference, with the scan tool, run and save a vehicle Scan Report and all related recorded data.
With the scan tool, erase all DTCs.
Turn the ignition off for a minimum of 10.0 seconds.
Turn the ignition on.
Using the When Monitored and Set Conditions above and recorded data, operate the vehicle in the conditions that set the DTC.
With the scan tool, read DTCs.

Did the DTC return?

Yes

Replace the Right Steering Wheel Switch (Speed Control Switch) in accordance with the Service Information. Refer to SWITCH, SPEED CONTROL, REMOVAL AND INSTALLATION .
Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .

If the vehicle is being serviced for a cruise control related concern and this DTC is stored, replace the Right Steering Wheel Switch (Speed Control Switch) in accordance with the Service Information. Refer to SWITCH, SPEED CONTROL, REMOVAL AND INSTALLATION .
If the DTC is stored: Test complete, the condition or conditions that originally set this DTC are not present at this time. Using the appropriate SYSTEM WIRING DIAGRAMS as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals, and correct pin tension.
Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .