Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Dodge and Ram >> 2021 >> Durango SXT Plus, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Cooling System (6.2L)) >> Engine >> Heater, Engine Block >> Installation

Heater, Engine Block: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Thoroughly clean the cylinder block core hole and the block heater seat.
    GC0143810Courtesy of CHRYSLER GROUP, LLC
  2. Insert the block heater assembly (2) into the block.
  3. With the block heater fully seated, tighten the bolt (3) to 12 N.m (106 in. lbs.) torque.
  4. Connect the power cord to the block heater (2).
  5. Install the starter. Refer to 6.2L .
  6. Connect the negative battery cable.
scientia non olet · About Mike's Workshop Manuals