Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Dodge and Ram >> 2021 >> Durango SXT Plus, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 7 (Cooling System) >> Engine >> Radiator, Engine Cooling >> Removal >> 3.6L

Radiator, Engine Cooling: Removal: 3.6L

WARNING: This page is about a different car, the 2021 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable.
  2. Remove the air cleaner body. Refer to REMOVAL BODY, AIR CLEANER, REMOVAL .
  3. Drain cooling system. Refer to STANDARD PROCEDURE .
  4. Remove upper radiator hose.
  5. Remove cooling fan assembly. Refer to FAN, COOLING, REMOVAL .
  6. Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
  7. Remove the lower belly pan.
    GC0095212Courtesy of CHRYSLER GROUP, LLC
  8. Remove lower radiator hose (1).
  9. Lower the vehicle.
  10. Remove the front bumper fascia. Refer to FASCIA, FRONT, REMOVAL .
    GC0144642Courtesy of CHRYSLER GROUP, LLC
  11. Remove the air deflectors (1).
    GC0144643Courtesy of CHRYSLER GROUP, LLC
    CAUTION:

    Bolts are installed with thread locker. Use hand tools to remove the upper radiator mounting bolts.

  12. Remove bolts (3) and the upper radiator isolator (1).
    GC0144644Courtesy of CHRYSLER GROUP, LLC
  13. Remove the lower condenser mounting bolts.
  14. Remove the bolt (2) located between the cooler lines.
  15. Using a suitable hanger. Support the condenser and remove the right side upper mounting bolt.
  16. Separate condenser assembly from radiator.
  17. Tilt radiator toward engine and remove radiator from vehicle.
scientia non olet · About Mike's Workshop Manuals